ICL, ICL Datasheet, ICL 3 1/2 Digit LCD Display, buy ICL The Maxim ICL and ICL are monolithic analog . descriptive excerpts from the original manufacturer’s data sheet have been included in this data. ICL datasheet, ICL circuit, ICL data sheet: INTERSIL – 3 1/2 Digit, LCD/LED Display, A/D Converters,alldatasheet, datasheet, Datasheet search.
|Published (Last):||7 July 2004|
|PDF File Size:||3.17 Mb|
|ePub File Size:||12.91 Mb|
|Price:||Free* [*Free Regsitration Required]|
See Tech Brief TB for details.
Datasheets search archive of electronic components datasheets
B1 maximum dimensions do not include dambar protrusions. Second, the reference capacitor is charged to the reference voltage. Ordering Information table – removed all non Pb-free parts all obsolete: An R-C oscillator using all three pins. To achieve maximum rejection of 60Hz pickup, the signal integrate cycle should be a multiple of 60Hz. Thus, it can be used as the negative supply for externally generated darasheet drivers such as decimal points or any other presentation the user may want to include on the LCD display.
All Rights Reserved Intersil and design is a trademark owned by Intersil Corporation or one of its subsidiaries. Temperature and weighing systems with a variable fare are examples. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries. Dambar protrusions shall not exceed 0. Submit Document Feedback 7 FN The oscillator frequency is divided by four before it clocks the decade counters.
The integrator output can swing to within 0. Due to their higher thermal resistance, plastic ic,7106 are poorer in this respect than ceramic. D, D1, and E1 dimensions do not include mold flash or protrusions. In this application, analog COMMON should be tied to the same point, thus removing the common mode voltage from the converter.
ICL Datasheet Intersil pdf data sheet FREE from
The sensor should dagasheet be placed in boiling water and the scale-factor potentiometer adjusted for a Finally, the true economy of single power supply operation ICLenables a high performance panel meter to be built with the addition of only 10 passive components and a display. Exposure to such conditions may adversely impact product reliability and result in failures not covered by warranty.
In all cases negligible DC voltage exists across the segments. Included are seven segment decoders, display drivers, a reference, and a clock.
However, care must be exercised to assure the integrator output does not saturate. Reliability reports are also available from our website at www.
ICL, ICL, ICLS Datasheet
For these critical applications the integrator output swing can be reduced to less than the recommended 2V full scale swing with little loss of accuracy. Datashedt b does not include dambar protrusion. No more than a 1mA load should be applied.
On the 2V scale, a 0. This difference in reference for positive or negative input voltage will give a roll-over error. Ivl7106 worst case condition would be a large positive common mode voltage with a near full scale negative differential input voltage.
See the ICL datasheet for an alternative. These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. An additional requirement of the integrating capacitor is that it must have a low dielectric absorption to prevent roll-over errors. You may report errors or suggestions for improving this datasheet by visiting www. This may burn the LCD display if maintained for extended periods.
N is the maximum number of terminal positions.